Customer Environment SilverFit Newton

To turn off the SilverFit Newton, follow these steps:

1. If you are in the middle of an exercise or test, finish it by pressing the arrow at the bottom left of the screen.
2. Press the 'Menu' button at the top right of the screen, then press the 'Shutdown' button.
3. You will be asked to confirm the shutdown. Press 'Shutdown' again.
4. The SilverFit Newton is completely off when the light in the power button is off. Note: Never unplug the system before it is fully turned off, as this can cause serious damage to the system or client data.

To change the strength equipment, follow these steps:

1. Make sure the system is turned off, as described in Chapter 4: 'Turning the system on and off.'
2. Remove the sensor cable from the SilverFit Newton.
3. Unplug the SilverFit Newton from the socket.
4. Move the SilverFit Newton to the desired location.
5. Position the system so that the patient has a clear view of the screen while training with the strength equipment.
6. Plug the SilverFit Newton back into the socket.
7. Plug the sensor cable of the new strength equipment into an available USB port on the SilverFit Newton.
8. You can now use the SilverFit Newton with the new strength equipment. Note: Never unplug the system from the socket before it is fully turned off, as this can cause serious damage to the system or client data.

To turn on the SilverFit Newton, follow these steps:

1. Make sure the power cable of the SilverFit Newton runs through the opening in the floor stand.
2. Ensure the plug is inserted into the socket.
3. Turn on the SilverFit Newton using the power button on the left side of the screen.
4. The light in the power button will turn on, and the SilverFit Newton will start up. This may take some time.